Wand/Staff/Rod Crafting

Send your ideas and suggestions here.

Moderator: Board moderators

Rednaxela
Senior member
Posts: 434
Joined: Wed Jan 26, 2005 5:13 am

Post by Rednaxela »

Mith wrote:Its just like making a high lvl monster - that is not charmable - and give it resist everything +100. Put in a treasure as big as you want, nobody will ever kill it (after a few attempts).
Unless people discover a weapons with a slay ability for it :P But yeah you have a point.
cavesomething
Forum Fanatic
Posts: 852
Joined: Sun Jun 13, 2004 2:07 am
Location: Hemel Hempstead

Post by cavesomething »

What about another way to bypass the whole rod level debate?

Create rods at the minimum level for the spell that they cast.

Then have enchantment scrolls of enchant rod, that increase the level of the rod. (maybe randomly up to ~5 levels, maybe one level maybe something slightly more complicated - involving sacraficing another rod of a higher level).

This would allow players to create powerful rods, just as they can create powerful weapons currently, but they would be unable to make stupid numbers of level 110 rods.

With the initial level being quite low, the cost to create them can be lower, and the side effects more benign (at least for simple spells).
Aaron
Senior member
Posts: 496
Joined: Sun Jan 30, 2005 9:04 pm
Location: New Jersey
Contact:

Post by Aaron »

no enchant rod scrolls. bad idea. enchanting exsisting rods to over 115 would be bad. and why not just use that higher level rod then, instead of sacraficing it?
Mith
Senior member
Posts: 348
Joined: Mon Oct 25, 2004 5:53 pm
Location: somewhere in nowhere

Post by Mith »

Aaron wrote:no enchant rod scrolls. bad idea. enchanting exsisting rods to over 115 would be bad. and why not just use that higher level rod then, instead of sacraficing it?
because that higher lvl rod might be a rod of an other spell...

and if it is possible to prevent armour being enchanted higher than +5, why should it be hard to prevent rods being enchanted higher than lvl 110?

i think cavesomething's idea makes sense.
Bibendi ergo sum
or rather: sum ergo bibendi
Aaron
Senior member
Posts: 496
Joined: Sun Jan 30, 2005 9:04 pm
Location: New Jersey
Contact:

Post by Aaron »

i just dont like the idea of enchanting rods higher than theyre supposed to be, you should have to go to more effort to do it than just find a scroll. but maybe if you did it in a forge with a scroll instead of metalsmith skill, and have a hard as hell quest for the scroll...
cavesomething
Forum Fanatic
Posts: 852
Joined: Sun Jun 13, 2004 2:07 am
Location: Hemel Hempstead

Post by cavesomething »

Aaron wrote: i just dont like the idea of enchanting rods higher than theyre supposed to be, you should have to go to more effort to do it than just find a scroll
i just dont like the idea of enchanting armour higher than it's supposed to be, you should have to go to more effort to do it than just find a scroll.

actually enchanting rods would be harder than enchanting armour under this proposal, I'll show you why.

Let us assume that you create a rod of comet.

comet is a ~ lvl 20 (can't remember exactly off-hand) spell

so a rod of comet will be created at level 20.

now, to enchant it as you do with armour, you need scrolls of enchant rod

look at my earlier post, I suggested the scale of their effects to be
cavesomething wrote: maybe randomly up to ~5 levels, maybe one level maybe something slightly more complicated - involving sacraficing another rod of a higher level
ok, so we have....
a) 1-5 levels (that will average 2.5 levels per scroll)
b) 1 level
c) something involving sacrificing higher level rods. (let us assume for the sake of this example that we set the rod level to the mean of the enchanted rod and the sacrificial rod (rounded down) ).

To acquire a level 110 rod then.....
a) requires on average (110-20)/2.5 = 36 scrolls
b) requires 90
c) assuming we only sacrifice lvl 110 rods, our new rod will go lvls 20-65-87-98-104-107-108-109.

this would require 7 scrolls and 7 lvl 110 rods.
even then, 109 would be the highest achievable, so those lvl 110 rods would need to be found.

Bear in mind that these scrolls would be like enchant armour scrolls, and not acquirable in unlimited quantities so not all rods would reach stupidly high levels.
Aaron
Senior member
Posts: 496
Joined: Sun Jan 30, 2005 9:04 pm
Location: New Jersey
Contact:

Post by Aaron »

but if you find a higher level rod, why not just use that one? or if its any rod, then you can just crap crappy rods like fairy fire, and use them.
cavesomething
Forum Fanatic
Posts: 852
Joined: Sun Jun 13, 2004 2:07 am
Location: Hemel Hempstead

Post by cavesomething »

Aaron wrote:but if you find a higher level rod, why not just use that one?
but if you find a more highly enchanted armour, why not just use that one?

I really don't see what your point is.
woo
Senior member
Posts: 427
Joined: Tue Jun 15, 2004 10:32 pm
Location: Atlanta, GA
Contact:

Post by woo »

I believe hes asking why sacrifice lvl 110 rods to build a rod, when you already have a lvl 110
Aaron
Senior member
Posts: 496
Joined: Sun Jan 30, 2005 9:04 pm
Location: New Jersey
Contact:

Post by Aaron »

and you dont have to sacrafice a higher level enchanted armour to enchant your armour. and i would use the higher level one anyway.

woo's interpertaion is right.
Post Reply